How to Install Your Artificial Grass Lawn

When you finally buy artificial grass from an artificial grass supplier, trader or importer follows these steps to lay man-made grass are –

Steps for Artificial Grass Installment

Step 1

If you’re installing artificial grass carpet over a garden soil, to make the space for a new base, dig the earth up to 3 to 4 inches from the top and remove the recent grass and plants.

To prevent slumping, allow rain wet, damp soil to dry before excavation. Compact the loose terrain with the help of hand tamp or by walking over it. A compact slope is recommended for better drainage.

Step 2

Install the grass turf over a well-draining soil such that the man made grass is permeable to the water and aggregate facets offer a good drainage layer. If there is no drain at the lawn, before you continue the installation, install a drainage process. If the area receives light rainfall, around the perimeter get away from a small drainage gap after every 15 cm.

Step 3

To counteract the lawn from separating or slumping over time, set up a waterproof border along the perimeter. You can use a plastic bender board or pour a concrete curb around the circumference. The border shouldn’t protrude above grass level in addition it might inhibit drainage.

Step 4

To prevent the growth of weeds, at the bottom of the excavated area or over the base material, place in a Geo textile barrier. This barrier discourages earthworms and gophers from digging through synthetic grass. If you have animal problems, you can also install a layer of rodent wires.

Step 5

Fill the excavated material with a mixture of finely crushed rock, decomposed granite with particles size less than 12 mm and gravel; up to 3 to 4 inches for superior drainage and prevent slumping. If you are installing the artificial your lawn carpet over a hard surface or concrete you can use a new rubber shock self-leveling compound.

Step 6

Smooth out the base content via a landscaping rake. To grade a flat surface with a 2-3% slope use string, ruler and bubble amount.

Step 7

To lubricate the particles for compaction, dust garden hose on gravel or sand. To compact the basic to a depth 90% less than its original depth, stream-lined the base with the help of roller compactor, plate compactor, or give tamp.

Step 8

While the base dries, unroll the actual artificial grass carpet on the sides. After the base dries off and it’s smooth and firm, continue the process.

Move 9

With the help of a friend, stretch out each strip of fake turf grass over the prepared base. The turf really should be install in such a way that all the blades of the turf are in identical direction else the grass will not give a natural appearance and feel.

Step 10

When required by the shape of the believed area, cut out the underside of the grass turf via a new carpet cutter.

Step 11

You can use a carpet stretcher to help stretch out the turf strips before you fasten them to protect the surface to the ground, lower the expansion due to heating and remove wrinkles.

Step 12

Place two tape close to each other and fold the edges back. Employ the lawn seaming material on the exposed base as well as cover it with an adhesive product. Fold the strip back on the seaming material and allow it to dry. You may as well lay a seaming tape on the ground and keep the remove over it or fasten them together with a stake